• Home

  • Products

    • Local Shipping
    • Tasmota
    • ESPHome
    • WLED
    • Homekit
    • Home Bridge
  • Forum

  • About Shipping

  • Contact Us

  • 更多

    Use tab to navigate through the menu items.
    0
    Para ver esto en acción, dirígete a tu sitio ya publicado.
    • Categorías
    • Todas las entradas
    • Mis entradas
    Cloom Ichmuch
    19 jun
    Editada: 21 jun

    [RESOLVED] GU10 unresponsive after ESPHome -> Tasmota lite upgrade

    en General Discussions

    Hello,


    I purchased ESPHome GU10 bulbs but wanted to switch to WLED to use ArtNet. I've read going to Tasmota lite ESP02 and then flashing to WLED would work but I have now the bulb stuck in blue and no wifi signal from it. I have tried to switch it on and off 5 times but no luck. For my ikea GU 10 I like Is there any video to help respecting the pace for the reset? Ikea has done one and it's useful:

    1. How to properly migrate from ESPHome to WLED on the Athom GU10 bulbs? 2. How can I bring back to life my bricked bulb? Thank you.

    3 respuestas0 comentarios
    0
    3 comentarios

    Comparte lo que piensasRegístrate para dejar un comentario.

    K
    komal khan
    komal khan
    21 ago

    On petsnews you can get any Information, Guide & Knowledge about Pets and their Life for free. Pets

    1

    C
    Cloom Ichmuch
    Cloom Ichmuch
    21 jun

    2. As it is a Tamosta-lite install I had to use the Tasmota reset method. Turning off 30s and then turning on and off 6 times for less than 10s and leaving the GU10 on the 7th time worked. Hourray! Source: https://tasmota.github.io/docs/Device-Recovery/#recovery-techniques

    1

    C
    Cloom Ichmuch
    Cloom Ichmuch
    21 jun

    And then I could flash the WLED firmware on it following:

    UPDATE : ANSWER FROM ATHOM

    • First execute "SetOption78 1" in the console of Tasmota

    • Select firmware upgrade, upload tasmota-minimal.bin and click start upgrade

    • Select the firmware upgrade again, upload the firmware of WLED and click to start upgrade

    • https://drive.google.com/drive/folders/1oYbf1ueoONFacbG2FQ1cIxjWo47cy1U9?usp=sharing


    Source: https://www.reddit.com/r/WLED/comments/pvtuvx/change_firmware_from_tasmota_to_wled_on_an_athom/ I used the firmware Athom_RGBCW.bin.gz

    0
    3 comentarios
    Entradas similares
    • 2 Gang switch SW1132EU not working after Tasmota upgrade
    • Tasmota Multi-Gang switches need upgrading!
    • Upgrading Tasmota & Bricked Bulbs

    ©2020 by athom.