• Home

  • Products

    • Local Shipping
    • Tasmota
    • ESPHome
    • WLED
    • Homekit
    • Home Bridge
  • Forum

  • About Shipping

  • Contact Us

  • 更多

    Use tab to navigate through the menu items.
    0
    Para ver esto en acción, dirígete a tu sitio ya publicado.
    • Categorías
    • Todas las entradas
    • Mis entradas
    Khoa Ton
    08 oct 2020
    Editada: 08 oct 2020

    Bulb Firmware Update Attempt to Tasmota 8.5.1 Bricked

    en Light

    Bulb stop responding after firmware upgrade to Tasmota 8.5.1. No WiFi accesspoint fallback seen.


    Is there a way to force WiFi accesspoint mode and firmware upload to the bulb when is in this mode?

    23 comentarios
    23 comentarios

    Comparte lo que piensasRegístrate para dejar un comentario.

    K
    Khoa Ton
    Khoa Ton
    08 oct 2020

    Tried "Fast Power Cycle Device Recovery" at: https://tasmota.github.io/docs/Device-Recovery/

    This did not work. Will be trying serial reflash next...


    Any hint as to how to serial flash this device?


    Looks like the GPIO pins are exposed. Would you have the pinouts? Need GND, VCC, TX, RX at minimum, and GPIOs would be wonderful!


    Thanks!

    Me gusta
    23 comentarios
    Entradas similares
    • My First Bricked Bulb
    • Is it possible to switch firmware from Homekit to Tasmota
    • Upgrading Tasmota & Bricked Bulbs

    ©2020 by athom.