• Home

  • Products

    • Local Shipping
    • Tasmota
    • ESPHome
    • WLED
    • Homekit
    • Home Bridge
  • Forum

  • About Shipping

  • Contact Us

  • 更多

    Use tab to navigate through the menu items.
    0
    Para ver esto en acción, dirígete a tu sitio ya publicado.
    • Categorías
    • Todas las entradas
    • Mis entradas
    Drew Perttula
    08 dic 2021

    WLED 7W bulb GPIO configuration

    en Light

    My new bulbs only displayed green-or-off. I had to go to Config -> LED prefs -> Hardware setup -> GPIOs and fill them in:

    r 4

    g 12

    b 14

    w 13

    c 5




    0 comentarios
    0
    Comentarios

    Comparte lo que piensasRegístrate para dejar un comentario.

    0 comentarios
    Entradas similares
    • Tasmota to WLED
    • How to factory reset Athom WLED Bulb?
    • Upgrade firmware on 2M 7W bulb from v8.4.0

    ©2020 by athom.