• Home

  • Products

    • Local Shipping
    • Tasmota
    • ESPHome
    • WLED
    • Homekit
    • Home Bridge
  • Forum

  • About Shipping

  • Contact Us

  • 更多

    Use tab to navigate through the menu items.
    0
    Para ver esto en acción, dirígete a tu sitio ya publicado.
    • Categorías
    • Todas las entradas
    • Mis entradas
    bh
    09 feb
    Editada: 09 feb

    au plug boot loop

    en Plugs

    i have a new au plug, and trying to connect to esphome/hass.

    The plug seems to be in a bootloop, and wont get an ip address... so cannot connect to it.


    The led is red for 30 sec, and then goes blue for 30 sec. So, turns itself on and then off every 30 sec. Then loops...


    Is there any failsafe mechanism for me to reset back to factory ?


    Any help is appreciated.


    If I press the button for 30 sec, what is it supposed to do ?


    Many thanks


    3 comentarios
    0
    3 comentarios

    Comparte lo que piensasRegístrate para dejar un comentario.

    bh
    12 feb

    I guess I must have bricked it. Shame. Is there anywhere I can send it back to factory ?

    It turns itself off/on every 30 sec. So something not right.

    Me gusta
    N
    Nick Harrison
    28 may
    Contestando a

    hi bh, did you ever have any luck with your plug. mine is in the same state & i'm trying to manually flash it again via my ftdi adapter. cant get it to flash mode though.

    Me gusta

    bh
    03 jun
    Contestando a

    actually I did fix it... it was tricky. But since then I bricked another - sad. The trick to fixing for me... was to actually change my wifi infrastructure to match that of what was mistakenly configured on the device... Once I did that I was able to get a handle on it, to upload a revised firmware. Tricky stuff.

    Me gusta
    3 comentarios
    Entradas similares
    • Is it possible to calibrate the plug ?
    • Can Athom Plug be Reset?
    • athom UK plug failures

    ©2020 by athom.