My switches are working few minutes. After few minutes i can operate by phone or voice but it is impossible to change state of switch by touch. Please watch the movie
https://youtu.be/yUJsYQVQjXo
What is wrong?
top of page
Para ver esto en acción, dirígete a tu sitio ya publicado.
11 comentarios
Ya no es posible comentar esta entrada. Contacta al propietario del sitio para obtener más información.
bottom of page
hello,
I had the same problem with three Athom 1Gang EU Swich.
That the touch button did not respond. And so I fixed it.
First I updated Tasmota to the latest version via OTA.
But the problem remained.
Then I took out the template and tried the configuration directly via Generic.
Problem remained.
Then I completely reset the configuration.
After restarting the device I was unable to connect to the Tasmota AP.
It was there but I couldn't connect to the Tasmota AP.
That's why I turned off the power of the switch.
The Tasmota AP could then be reconnected.
Configured via Generic without template.
Problem is gone.
I repeated the procedure on the other switches.
All switches work.
I hope this helps you.
greeting Martin