• Home

  • Products

    • Local Shipping
    • Tasmota
    • ESPHome
    • WLED
    • Homekit
    • Home Bridge
  • Forum

  • About Shipping

  • Contact Us

  • 更多

    Use tab to navigate through the menu items.
    0
    Para ver esto en acción, dirígete a tu sitio ya publicado.
    • Categorías
    • Todas las entradas
    • Mis entradas
    pablomedok
    09 dic 2020

    Wifi reconnect

    en Wall Switch

    Is there a way to configure auto-reconnect or at least a power on connection delay.


    I have a Homekit version of 2 gang switch with mechanical buttons that is installed in my summer house. It controls outside lights via Homekit automations. Power supply for the house is not stable, so it loses power a couple of times a month. Every time power recovers the switch tries to reconnect to the wifi-router, but it's not ready yet (it takes up to 2 minutes to initialize). Or maybe the swithc resets after a power outage? If so, that's even worse. So, the switch stays disconnected (with a pink LED) in unknown state (on or off) until I come to the house and reset connection to the Wifi.


    Is there a way to solve this problem?

    7 comentarios
    0
    7 comentarios

    Comparte lo que piensasRegístrate para dejar un comentario.

    E
    Eliza Bala
    Eliza Bala
    06 sept 2021

    It often comes into question what is the best wall mount for such big TVs, can you mount a 75-inch tv on the wall, are tv wall mounts universal, what size screws are used to mount a Samsung tv, and even can you hang a curved tv on a regular wall mount? Read till the end to have all such questions answered.

    There is also a guide in the end after https://wallmountedhub.com/best-wall-mounts-for-82-inch-tv/

    Me gusta

    pablomedok
    14 jul 2021

    I've already contacted and I was told that my version of athom switch is not supported. Which is dumb.

    Me gusta

    Athom_Support
    14 jul 2021

    If you need to upgrade, please contact by email, support@athom.tech

    Me gusta

    Athom_Support
    02 jun 2021

    If the current version is greater than or equal to 0.3, it can be solved by upgrading the firmware, if you want to upgrade, you can contact us by email

    Me gusta
    F
    Fernando Alvim
    Fernando Alvim
    11 jul 2021
    Contestando a

    @Athom_Support How do I update my E27s so that in case of a power failure they reconnect to my wifi network without needing to reconfigure them?

    Me gusta

    K
    Kost Ski
    Kost Ski
    04 ene 2021

    I have same issue. Supports please make update to resolve.

    Me gusta

    oren.bar10
    11 dic 2020

    I have same issue with smart plug devices, it seam that WiFi scan after power up is too short and by the time my Network recover from power up the switch stop trying to connect. Which then i need manually to force it to re-connect by removing it's from power and connect it back to power.

    Is there other solution for this problem?

    Me gusta
    7 comentarios
    Entradas similares
    • Configuration of Tasmota WiFi Switch
    • Change Wifi network on my switches
    • Can’t connect to wifi

    ©2020 by athom.