• Home

  • Products

    • Local Shipping
    • Tasmota
    • ESPHome
    • WLED
    • Homekit
    • Home Bridge
  • Forum

  • About Shipping

  • Contact Us

  • 更多

    Use tab to navigate through the menu items.
    0
    Para ver esto en acción, dirígete a tu sitio ya publicado.
    • Categorías
    • Todas las entradas
    • Mis entradas
    starfel1982
    17 sept

    Is my LED controller bricked?

    en WLED Related

    I just received my LED controller (the smaller, 2amp version) - after hooking it up to a 5v power supply by itself (no led strip), I connected to the AP, setup the network configuration. So far so good, after this I added it in the WLED app, as well as connected it through my browser, again, so far so good.

    At this point i disconnected the power and left the house for a bit.


    After coming back home, I reconnected the power supply to the controller, and nothing works. I cannot connect through it from the app, nor is it even connected to the wifi anymore (i checked this by doing a PING to the ip as well as checking the connected clients from my router setup. It's simply not there.


    I tried multiple ways of resetting the device, holding the button 7 seconds according to the manual. 10 seconds according to the forum, it just doesn't work. Am i doing the reset the wrong way? Is there another procedure to get this device to return to factory settings?


    Is my LED controller bricked? I am finding no luck whatsoever to get this thing to reset. Kindly help!


    Many thanks in advance.

    0 comentarios
    0
    Comentarios

    Comparte lo que piensasRegístrate para dejar un comentario.

    0 comentarios
    Entradas similares
    • LED Strip Controller disconnects when LEDs connected
    • Controlling led on smart plug PG01
    • Have I "soft bricked" my LED controller?

    ©2020 by athom.