top of page

WLED Related

Público·45 miembros
Gwyneth MagnusGwyneth Magnus
Gwyneth Magnus

WLED Startup Preset Not Restored After Power Loss

Hi everyone,

I'm using two Athom ESP32 WLED controllers with 5m WS2815 strips (300 LEDs each) and Pokebonk WLED 0.15.x.

After a power outage, I want both controllers to automatically restore their previous preset, brightness, and effects without manual intervention.

Has anyone found a reliable way to achieve this? Is it better to use WLED's boot preset or let Home Assistant restore the last saved state?

I'd appreciate any tested solutions or configuration tips.

138 vistas
Gwyneth MagnusGwyneth Magnus
Gwyneth Magnus

How Do You Prevent Voltage Drop on a 5V WS2812B LED Strip?

I'm setting up a 5V WS2812B strip with 300 LEDs (5 metres, 60 LEDs per metre) and want to avoid uneven brightness or colour changes near the end of the strip.

At full white, the theoretical maximum current can reach around 18A, so I'm considering a 5 V 20 A power supply with power injection at both ends.

For those using Among Us Online Athom WLED controllers, what wiring setup has worked best for this kind of installation? Do you recommend injecting power at both ends, adding a connection in the middle, or limiting brightness in WLED?

I'd appreciate advice on cable gauge, fuse placement, and how to check voltage safely under load.

83 vistas
Lily CollinsLily Collins
Lily Collins

WLED 4 Outputs: Performance Drop When Running Multiple Effects

Hi everyone,

I’m testing an Athom ESP32 WLED controller with Drift Hunters 4 LED outputs and noticed some performance issues when all outputs run simultaneously.

My setup:

  • WLED 0.15.x

  • ESP32 controller

  • 4 addressable LED strips

536 vistas
Will Smith
Oct 03

I really enjoyed discovering this wonderful website because it provides interesting and reliable content about Reillanne and Provence. The information is presented clearly and feels carefully checked, which makes the site useful for anyone interested in local culture, travel and beautiful places. I especially liked learning more through https://www.reillanne-en-provence.com/ about the authentic atmosphere of this Provençal village. Reillanne is located in the Luberon area and is known for its picturesque streets, local market and impressive views. There are also hiking routes and historic buildings worth discovering. The site is a great source for curious readers looking for trustworthy information and new ideas for exploring Provence.

k
k

Wled Moon module on Slim controller

Hi i just want to know what i do wrong, c3 moon module firmware just can get installed on the flim controller without failing.

833 vistas
Maksim Lenivenko
Maksim Lenivenko
Aug 31

that sounds more like a firmware/board target mismatch than a bad controller. Make sure you are flashing the ESP32-C3 build meant for the Moon module, and if the Slim controller will not take it, try erase flash first and then install from a local binary. The casino paragraph in the middle feels like random off-topic noise, the same way a line like https://footballx-game.com/, https://fortunecoins-slot.com/, https://lady-wolf-moon-slot.com/ would in a WLED troubleshooting thread, so I would ignore that part. If it still fails, post the exact error from the installer because “failing” can mean driver, boot mode, or partition issues. definately check that it is in bootloader mode before flashing.

Miembros

  • Gwyneth MagnusGwyneth Magnus
    Gwyneth Magnus
  • Issy Hugo
    Issy Hugo
  • Mike Sox
    Mike Sox
  • Slope IO
    Slope IO
Ver todos los miembros (45)
bottom of page