Open Smart Home Hardware Forum

Most people should get dental scaling every 6 to 12 months, depending on their oral health. If you have gum disease, your dentist may recommend more frequent cleanings. For people with good oral hygiene and no signs of gum disease, scaling may be needed less often. Your dentist will recommend a personalized schedule based on your oral health needs.

Hey everyone, I recently bought the Athom WLED 2812B LED Strip Controller, but I overlooked its 3A output limit. My setup consists of two SK6812 LED strips, each with 81 LEDs. According to the product description, each LED consumes a maximum of 0.3W (Amazon link).So in total: • Power consumption: 81 LEDs × 0.3W × 2 strips = 48.6W • Required power supply: 5V / 9.72A My Plan I want to connect both LED strips to one controller using a JST Y-cable (Amazon link), with the strips mirroring each other. Since the 3A max output of my current controller is too low, I'm looking for a new WLED-compatible controller that: • Supports Home Assistant integration • Allows OTA updates via Home Assistant Power Supply Concerns Right now, I'm using this 5V 10A power supply: Amazon link.However, I've read that 5.5mm barrel connectors might have a 3A limit, which could be an issue. Questions 1. Can anyone recommend a suitable WLED controller for my setup? 2. Is my current power supply sufficient, or should I switch to a different one? 3. Would using the 5.5mm connector be a potential bottleneck? I’d really appreciate any advice—thanks in advance!

Hi all, Firmware: v2.0.7 (ESPHome 2024.12.4) I have just purchased a couple of Athom Smart Plug V2 with ESP firmware and connected them to Home Assistant. They are working OK, except for restarting themselves at random times for what appears to be no reason. Wifi connection is good with the AP only a few metres away. Any suggestions greatly appreciated. TIA