Hi! I haver updated The binaries of a athom bulb 15, i was wled and tried to change to esphome, but this proccess brick the device, how can i do this via the serial port? I noticed that it has gnd, vcc, but I don't know which pins are gpio0 and rx/tx.
top of page
bottom of page
Hello,
I have the same problem and was able to disassemble the plastic dome by steady gently pushing forward and backward to loosen the glue. I can see the pins corresponding to this.
But wich one is RX, TX, Gnd, 0, 3v etc?
Anyone Ideas?
Best